Talk to an engineer

Prototype · patented

Wireless charging for autonomous drones

A patented landing pad that charges drones as soon as they touch down, so they can land, recharge and take off again with no one swapping batteries.

Vehicles
Multirotor drones, adaptable to ground and water drones
Ground side
Transmitter pad (GA) with power electronics and user interface
Drone side
Lightweight receiver pad (VA) connected to the battery
Charging
Starts by itself when the drone lands on the pad
Intellectual property
Patented WPT charging system
Power class
Low
Wireless charging for autonomous drones: Drone charging pilot

01Context

Drones inspect power lines, wind farms, solar plants and pipelines, collecting precise data for predictive maintenance across renewable and conventional energy infrastructure. Monitoring and surveillance missions need them to operate continuously and on their own.

02Challenge

Endurance is the big limit. Even the best drones fly for about half an hour, and every battery change needs a person: land, switch off, swap and store the battery, power up, take off again. Operations stop, and fully autonomous missions become impossible.

03Solution

  1. Land and charge

    The drone lands on the transmitter pad, by autopilot and GPS repositioning, and charging starts automatically through its receiver pad.

  2. Monitored battery

    Real-time battery monitoring decides when to return to the pad and when the drone is ready to take off again.

  3. Sealed and connector-free

    No exposed contacts to wear, corrode or short: the pad works in rain, dust and remote sites, and needs little maintenance.

  4. One system for many drones

    The same architecture adapts to aerial, ground and water drones, and can run from the grid or from renewable sources.

04Results

  • Drones land, charge and take off again with no human intervention.
  • Continuous operations for monitoring and surveillance missions.
  • No battery swaps, no cables, no connectors to maintain.
  • A patented WPT charging system, ready for autonomous drone fleets.

How it works4 steps

Land, charge, take off.

LANDINGCHARGINGTAKE-OFF GROUND ASSEMBLY · GATransmitter pad POWER SUPPLYGrid or renewables CORE POWER ELECTRONICSControl and UI BATTERYCharged at every landing VEHICLE ASSEMBLY · VARX coil under the drone
  1. 01Battery check

    Live monitoring tells the drone when to come back.

  2. 02Landing

    Autopilot and GPS land it on the pad, coils aligned.

  3. 03Wireless charging

    Charging starts on touchdown. Nothing to plug in.

  4. 04Take off

    Charged, it takes off and resumes the mission.

On site1 photo

DASHBOARD⇄ TWO-WAY● LIVE TRAY 01 · BATCH A-1142READ ✓TRAY 02 · BATCH A-1143READ ✓TRAY 03 · BATCH A-1144READ ✓ SCANNING TRAYS CHARGING RFID CEILING RAIL PLANT TRAYS · EVERY BATCH TAGGED TX COIL CORECONTROL GRID RFID ⇅ RX COILCHARGES THE READER Next projectGreenhouseContinuous RFID power for automated seeding linesRead the case

Similar challenge?

Tell us about your vehicles, robots or site. An engineer will get back to you.

Talk to an engineer