In progress
Continuous RFID power for automated seeding lines
Wireless charging for the RFID readers on an automated seeding line: every bar recharges at the end of its scan pass, with no connectors and no downtime.
- Client
- A greenhouse
- Application
- RFID tracking on an automated seeding line
- Air gap
- Up to 5 cm, coil to coil
- Power class
- Low
01Context
An automated seeding line uses motorized bars fitted with RFID readers to track every plant batch.
02Challenge
Keeping those readers charged meant manual intervention that interrupted scanning and added operational overhead.
03Solution
- Fixed transmitter
Inverter, compensation network and TX coil, mounted on the line.
- Receiver on every bar
Recharges the RFID reader automatically at the end of every scan pass, with an embedded low-power controller and switching regulation on the receiving side.
- Planar PCB coils
Coils on multilayer PCB for geometric precision and repeatable manufacturing, engineered for a coil-to-coil gap of up to 5 cm.
- Two-phase roll-out
A first set of systems deployed in the field for development and validation, then scaled up across the whole line.
04Results
- RFID readers recharge by themselves at the end of every scan pass.
- No physical connectors and no downtime for charging.
- Unit cost optimized through economies of scale as the system extends across the line.
From the project.
The motorized boom that will host the RFID reader and the WPT receiver
Next project
Wireless charging for body-worn electronicsRead the case
Similar challenge?
Tell us about your vehicles, robots or site. An engineer will get back to you.